Finally, before we dive too much further, this is as good a place as any to drop the full price list:

The quick tooling changeover is pretty important because Datum does quite a few of them over a shift. Eaton said the company averages 10 to 15 setups per shift between the two P2 panel benders and two punching machines that make up a cell. The jobs are run according to length. For instance, the operator that runs all four machines in the cell will set up 36-inch parts and run all that size. Then a tool changeover will occur to run 42-in. parts.

Some of the vehicles had no Chinese labels on brake fluid tanks, while some demonstrated a real motor capacity that differed from the one on the label, according to the General Administration of Customs (GAC).

And finally, the Greenworks Digi Pro comes complete with a unique, form-fitting, zip-up fabric bag/case. I don’t quite know what to think about this because I just learned these existed while unpacking it from the box.

“She doesn’t ask for anything, but I want her to be in a little style and comfort,” he said. “Every time I’ve seen her, she’s doing some type of fundraiser, always doing stuff for other people. It’s the holidays, and she does a lot for everybody else, so why not give it a shot?”

Here is the deal. I get we are on the same side but you focus on the very small details yet miss the big picture.

This conversation is moderated according to USA TODAY’s community rules. Please read the rules before joining the discussion.

From a technology standpoint, the panel bender relies on bending blades to make the programmed bends, instead of a ram that forces the sheet metal blank into a die opening. A machine operator inserts the blanks into the machine where hold-down clamps keep the blank from moving while a pair of bending blades contact the material to make upward or downward bends. The blades do not move in a straight up-and-down line, but rather oscillate around a single bend point until the desired angle of the bend is achieved.

The Greenworks Digi Pro flashes an alarm whenever the brake lever is applied. That’s okay, but the insistent chirping sound will make you switch off the saw long before its one-minute timeout interval. This can dissuade a user from relying on the brake as a safety device when adjusting or carrying the saw around as should be the habit. The Oregon saw has a more useful brake alarm that only beeps after the brake is activated during use or when the trigger is pulled with the brake applied.

Voltage regulators (also called "power scaling," "master voltage," and "xxx") are achieved via a network of components within the amp’s power supply, governed by a potentiometer that allows the player to reduce the DC voltages that feed the tubes. These components are responsible for how efficiently they operate and, therefore, how much they amplify the guitar signal that passes through them. Some such systems operate exclusively on the output stage, while others operate on the output and preamp stages alike. Fans of this solution uphold that it provides a natural-sounding way of reducing your volume level, since you aren’t changing the gain and tone settings by some external means, only reducing the amount of amplification that the tubes deliver.

CCC quoted a long series of not-included operations in replying to a user asking in 2018 about adjacent panel repair on a 2017 Toyota Corolla.

Editor’s Note: This article was republished as part of Pro Tool Review’s Best of 2017 week. It originally published earlier in 2017.